Non-standard delivery cost - Hazardous network only - delivery cost upon request. 

Junckers BasePrime is a quick-drying primer which in combination with Junckers solvent based or water based lacquers is suitable for sanded and untreated wooden floors, including most exotic wood species.

The primer gives light-coloured wood species a golden appearance.

Junckers BasePrime should only be used as the sealing coat for the wood fibres. For priming of ammonia-treated wood Junckers PreLak or Junckers ProSeal is recommended.

Product: Priming lacquer based on alcohol-solvent. Package sizes: 5 litre 
Appearance: Colourless.

Technical Data

Coverage: 10 m2 per litre. Before use: Stir well before use.

Application tools: Brush or short-pile varnishing roller. Do not apply by spraying.

Substrate temperature: Minimum 15° C.

Dilution: Delivered ready for use. Dilution is not recommended.

Drying time: Dry to touch after approx. 15 min. at 20° C and 50 % RH. Cleaning of tools: White spirit.

Storage: Lasts for 2 years if unopened and stored at 20° C. Not to be exposed to temperatures above 40° C.

SYSTEM RECOMMENDATIONS

High traffic areas: 1 coat BasePrime 10 m²/litre + 2 coats HP Commercial or Strong 10 m²/litre.

Low traffic areas: 1 coat BasePrime 10 m²/litre + 2 coats ProFinish or ProTech 10 m²/litre.

Sport areas: 1 coat BasePrime 10 m²/litre + 2 coats HP Sport 10 m²/litre.

DIRECTIONS FOR USE

Untreated/sanded floors: Ensure that the surface is absolutely clean, dry and free from dust, wax, grease, polish etc. Sand the surface to remove dirt and irregularities. The Ćnal sanding should be carried out by using sandpaper grit 120-150. Vacuum thoroughly and wipe oĄ with a cloth well wrung in clean water.

• Prime with one coat of BasePrime and leave to dry.
• Sand with sandpaper grit 150-180 along the fibres of the wood.
• Vacuum sanding dust and wipe off with a cloth well wrung in clean water.
• Apply 2 finishing coats of top-lacquer according to one of Junckers' system recommendations.

Previously sealed floors:

• Machine sand the floor by using sandpaper grit 24-36 to strip old coats.
• Then remove abrasion marks with grit 60-80.
• Proceed as described under “Untreated/sanded floors”.